Performance of maturity method for estimation of concrete strength based on cubic specimens

Authors

DOI:

https://doi.org/10.54355/tbus/1.4.2021.0008

Keywords:

strength gain, sensor, concrete, construction, destructive method, non-destructive method

Abstract

To assess the condition of the structures of buildings and structures, a comprehensive analysis of the factors affecting their performance characteristics - concrete strength, protective layer, and rebar diameter, thermal conductivity and moisture content of concrete, adhesion of protective and facing coatings, frost resistance and water resistance of concrete - is required. However, with all the variety of monitored parameters the control of concrete strength has a special place because when assessing the condition of the structure the determining factor is the compliance of the actual strength of concrete to the design requirements. This paper presents studies on the determination of concrete strength based on modern technology, wireless sensor as well as instrumentation IPS. These methods are particularly effective in the case of non-linear relationships between different system parameters, as in the behavior of concrete parameters. They can also provide rapid measurements by continuously monitoring the internal condition of the reinforced concrete structure. The found graduation dependences and determination coefficients equal to 0.9234 and 0.9702 justify the convergence of the results of the two methods of strength gain control.

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

Author Biographies

Rauan Lukpanov, ENU-Lab, L.N. Gumilyov Eurasian National University, Nur-Sultan, Kazakhstan

PhD, Associate Professor

Shyngys Zharassov, Department of Civil Engineering, L.N. Gumilyov Eurasian National University, Nur-Sultan, Kazakhstan

PhD Student

Timoth Mkilima, Pan-African University Institute for Water and Energy Sciences (including Climate Change) c/o Tlemcen University, Tlemcen, Algeria

Research Fellow

Aliya Aldungarova, Department of Architecture and Design, Toraighyrov University, Pavlodar, Kazakhstan

PhD, Associate Professor

References

Concrete compressive strength prediction using non-destructive tests through response surface methodology / A. Poorarbabi, M. Ghasemi, M. Azhdary Moghaddam // Ain Shams Engineering Journal. — 2020. — Vol. 11, No. 4. — P. 939–949. https://doi.org/10.1016/j.asej.2020.02.009 DOI: https://doi.org/10.1016/j.asej.2020.02.009

Determination of concrete quality with destructive and non-destructive methods / H. Kibar, T. Ozturk // Computers and Concrete. — 2015. — Vol. 15, No. 3. — P. 473–484. https://doi.org/10/gm55ms DOI: https://doi.org/10.12989/cac.2015.15.3.473

Strength Prediction by Using Maturity for Portland Cement Concrete Pavement Construction at Airfields / R.O. Rasmussen, J.K. Cable, D.J. Turner, G.F. Voigt // Transportation Research Record: Journal of the Transportation Research Board. — 2004. — Vol. 1893, No. 1. — P. 18–25. https://doi.org/10.3141/1893-03 DOI: https://doi.org/10.3141/1893-03

Closure to “Load Transfer Curve Analyses of Drilled Shafts Using Crosshole Sonic Logging Test” by Won-Taek Hong, Seung Yong Shin, Min-Chul Park, Jong-Sub Lee, and Myung Jun Song / W.-T. Hong, S.Y. Shin, M.-C. Park, J.-S. Lee, M.J. Song // Journal of Geotechnical and Geoenvironmental Engineering. — 2020. — Vol. 146, No. 7. — С. 07020009. https://doi.org/10.1061/(ASCE)GT.1943-5606.0002285 DOI: https://doi.org/10.1061/(ASCE)GT.1943-5606.0002285

A review on sensors and systems in structural health monitoring: current issues and challenges / M.A. Hannan, K. Hassan, K.P. Jern // Smart Structures and Systems. — 2018. — Vol. 22, No. 5. — P. 509–525. https://doi.org/10.12989/SSS.2018.22.5.509

Non-destructive concrete strength evaluation using smart piezoelectric transducer—a comparative study / Y.Y. Lim, K.Z. Kwong, W.Y.H. Liew, C.K. Soh // Smart Materials and Structures. — 2016. — Vol. 25, No. 8. — P. 085021. https://doi.org/10.1088/0964-1726/25/8/085021 DOI: https://doi.org/10.1088/0964-1726/25/8/085021

Modeling a set of concrete strength in the program ELCUT at warming of monolithic structures by wire / M.O. Dudin, N.I. Vatin, Yu.G. Barabanshchikov // Magazine of Civil Engineering. — 2015. — Vol. 54, No. 02. — P. 33–45. https://doi.org/10.5862/MCE.54.4 DOI: https://doi.org/10.5862/MCE.54.4

Nondestructive Evaluation of Damage in GFRP Bars Using Ultrasonic Guided Waves / P. Wiciak, M.A. Polak, G. Cascante // Journal of Composites for Construction. — 2021. — Vol. 25, No. 6. — P. 04021055. https://doi.org/10.1061/(ASCE)CC.1943-5614.0001166 DOI: https://doi.org/10.1061/(ASCE)CC.1943-5614.0001166

The Behavior of Non-Destructive Test for Different Grade of Concrete / M. Abdul Rahim, S. Shahidan, L.C. Onn, Poh Cheong (Malaysia) Sdn Bhd, Lot 1250/1251 Jalan Seelong, 81400 Senai, Johor, MALAYSIA, N.A.A. Saiful Bahari, N. Abd Rahman, A. Ayob // International Journal of Integrated Engineering. — 2020. — Vol. 12, No. 9. https://doi.org/10/gnq334 DOI: https://doi.org/10.30880/ijie.2020.12.09.001

The Relationship Between Concrete Strengths Obtained by Destructive and Non-destructive Methods / Ş. Karahan, A. Büyüksaraç, E. Işık // Iranian Journal of Science and Technology, Transactions of Civil Engineering. — 2020. — Vol. 44, No. 1. — P. 91–105. https://doi.org/10/gnq2sz DOI: https://doi.org/10.1007/s40996-019-00334-3

Compressive strength and elasticity module of concrete using non-destructive techniques (NDT) / M.V. de Camargo, V.J. Ferrari // Matéria (Rio de Janeiro). — 2021. — Vol. 26, No. 3. — P. e13047. https://doi.org/10/gnq34d

The early-age prediction of concrete strength using maturity models: a review / K. Nandhini, J. Karthikeyan // Journal of Building Pathology and Rehabilitation. — 2021. — Vol. 6, No. 1. — P. 7. https://doi.org/10.1007/s41024-020-00102-1 DOI: https://doi.org/10.1007/s41024-020-00102-1

Comparison of calculating methods and applications of different concrete maturity / D. Geng, N. Dai, X. Jin, E. Miao // Journal of Physics: Conference Series. — 2021. — Vol. 2011, No. 1. — P. 012022. https://doi.org/10.1088/1742-6596/2011/1/012022 DOI: https://doi.org/10.1088/1742-6596/2011/1/012022

ASTM C1074-17 Standard Practice for Estimating Concrete Strength by the Maturity Method. — 2019. — P. 10.

GOST 22690-2015 Concretes. Determination of strength by mechanical methods of nondestructive testing. — 2015. — P. 24.

GOST 10180-2012 Concretes. Methods for strength determination using reference specimens. — 2012. —P. 36.

Downloads

Published

2021-12-13

How to Cite

Lukpanov, R., Zharassov, S., Mkilima, T., & Aldungarova, A. (2021). Performance of maturity method for estimation of concrete strength based on cubic specimens. Technobius, 1(4), 0008. https://doi.org/10.54355/tbus/1.4.2021.0008

Most read articles by the same author(s)

<< < 1 2